Description
Original rear fog light on the driver’s side for PEUGEOT 3008 first generation. With bulb.
Product Overview
This genuine rear fog light is designed for the Peugeot 3008 (first generation). Supplied with the bulb installed, it restores correct rear visibility and signaling in poor weather conditions. Built to OEM specifications, it matches shape, mounting points and electrical connector to ensure a straightforward replacement for professional garages and DIY mechanics.
Benefits
- Direct fit replacement for a perfect match with original mounting and connector.
- Supplied with bulb included — reduces parts and labor time.
- Improves safety by restoring rear fog light function and visibility in fog, heavy rain or snow.
- OEM-quality optics ensure correct light pattern and legal compliance.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 3008 I
- Product Codes: 9685463380, 6350HG
- Additional Numbers: 6350HG
Fitment And Compatibility
Intended for the first generation Peugeot 3008. Always check physical fitment and connector type against the original part before installation. This unit is the same style and mounting arrangement used on factory rear bumper assemblies for the specified model.
Installation Recommendations
Typical replacement can be completed in a workshop or at home with basic tools. Recommended steps:
- Open the tailgate and remove inner trim panels to access the fog lamp area (some models may require removal of part of the bumper or inner wheel arch liner).
- Disconnect the electrical connector and remove the fixing screws or clips holding the lamp in place.
- Remove the old unit, transfer any retaining brackets if required, and fit the new lamp. Ensure the bulb is correctly seated.
- Reconnect the electrical connector, test the fog light function, and refit trim panels.
Safety Tips: Disconnect the battery or isolate the circuit before working on vehicle electrics to avoid short circuits. Use dielectric grease on connectors to slow corrosion. Verify lamp alignment and sealing to prevent water ingress.
Why This Part Fails Most Often
- Bulb Failure: The most common issue is a burnt-out bulb — replacement restores function quickly.
- Water Ingress: Damaged seals or cracked lenses allow moisture to enter, causing corrosion and intermittent electrical faults or condensation that reduces light output.
- Impact Damage: Rear-end knocks or minor collisions often crack or misalign the fog lamp housing.
- Corroded Connectors: Road salt and moisture can corrode contacts, leading to poor connection and flickering.
Additional Advice
When replacing the fog lamp, inspect surrounding seals and the wiring harness for damage. If the original failure was caused by moisture, replace seals or apply appropriate sealant and ensure the drainage paths are clear. After installation, check the lamp operation from inside the vehicle and from behind to confirm correct intensity and aiming.
