Peugeot 3008 bulb socket 9805510480

Description

Bulb socket for the right rear lamp for PEUGEOT 3008 cars of the first generation facelift
Side behind the passenger
With a piece of wiring

Part description

This bulb socket 9805510480 is a used original Stellantis Citroën Peugeot part, intended for the rear lamp. Thanks to the attached piece of cabling, it is suitable as a replacement in case of damage to the original socket, overheating of the contacts or problems with the power supply of the bulbs in the rear light.

It is important for auto mechanics and DIYers that this is a part that is often searched for precisely by serial number. If you need Peugeot 3008 bulb socket 9805510480, this piece can be a practical solution to repair the rear light without having to change the whole lamp.

Technical information

• Manufacturer: Stellantis Citroën Peugeot
• Model: Peugeot 3008 I
• Other numbers: not specified

Product codes

• Product codes: 9805510480

Installation recommendations

Generally/typically for this type of part, the exact replacement procedure may vary depending on the specific lamp design and access in the vehicle. Below is a practical general procedure for replacing the tail light bulb socket with wiring.

1) Before assembly

• Check whether the shape of the socket, the number and distribution of contacts and the design of the connector match the old part.
• Compare the length and condition of the attached piece of wiring.
• Inspect the contacts for oxidation, overheating or mechanical damage.
• Check the condition of the bulbs and sockets if they are part of the original unit.

2) Necessary tools and materials

• common hand tools
• screwdriver or plastic pry bar for removing covers
• work gloves
• electrical contact cleaner
• cloth or paper towels

3) Step-by-step assembly procedure

1. Turn off the ignition and secure the vehicle against movement.
2. Access the rear lamp according to the car design by removing the inner cover or access panel.
3. Carefully disconnect the electrical connector from the original bulb socket.
4. Remove the original socket from the lamp so as not to damage the plastic locks or contacts.
5. Compare the old and new part side-by-side, especially seating, contact surfaces and wiring routing.
6. In case of light contamination, clean the connector and contacts with a suitable preparation for electrical connections.
7. Insert the new socket into the lamp in the correct position and check that it is securely seated.
8. Connect the electrical connector or connecting wiring so that the joint holds well and is not under tension.
9. Check that the wiring is not pinched, twisted or routed where it could rub.
10. Reinstall all removed covers and fasteners.
• 4) Post-assembly checks and test drive/function verification
  • Try out all the rear light functions that are routed through this socket.
  • Observe that the lighting does not flicker, drop out, or show irregular contact.
  • After a short ride, recheck the seating of the socket and the condition of the connector.

  5) The most common assembly mistakes + how to avoid them

  • Part exchange – always compare the part number and design.
  • Insufficient seating of the base – after assembly, check that the part is seated correctly and is not loose.
  • Leaving oxidized contacts – it is advisable to clean the contacts before assembly.
  • Damage to plastic locks during disassembly – work carefully and without excessive force.
  • Pinched or strained wiring – route the cable loosely and away from friction points.

  Reasons why the part is damaged

  • long-term thermal stress from light bulbs
  • oxidation and corrosion of contacts due to humidity
  • transient resistance on loose or dirty connections
  • mechanical damage when changing bulbs or handling the lamp
  • damage or fatigue wear of the connected cabling