Description
Wiring Harness For Driver Seat For Peugeot 207 First Series
!!!!! ATTENTION – This Is A Driver Seat !!!!!
Product Description
This driver seat wiring harness is designed for the Peugeot 207 first generation and provides the electrical connection between the seat’s components and the vehicle wiring loom. It is commonly referred to as a seat loom, seat wiring harness or driver seat cable harness and is often searched for by its product code 6545GC. The harness carries signals and power for seat adjustment motors, heating elements, occupancy/weight sensors and safety circuits depending on vehicle trim.
Compatibility
- Peugeot 207 (First Generation)
- Trim Dependent: Vehicles Equipped With Electric Seat Adjustment, Seat Heating Or Occupancy/Side Airbag Systems
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 207 (First Series)
- Product Codes: 6545GC
- Other Numbers: –
Key Functions
- Provides Power And Signal Paths For Seat Adjustment Motors (Where Fitted).
- Supplies Seat Heating Elements And Controls (Where Fitted).
- Connects Occupancy/Weight Sensors And Seatbelt Buckle Switches To The Airbag/BCM Systems.
- Integrates Side Airbag Connector Circuitry On Seats Equipped With Side Airbags.
Common Symptoms Of A Faulty Harness
- Loss Of Electric Seat Adjustment Or Intermittent Operation.
- Seat Heating Stops Working Or Works Intermittently.
- Airbag Warning Light Or Occupancy Sensor Faults Triggered On Dashboard.
- Intermittent Electrical Faults Localized To The Seat Area Or Connector Damage Visible On Inspection.
Why This Part Fails
Driver seat wiring harnesses are exposed to repeated flexing, abrasion and mechanical stress as the seat moves. The most common failure causes are broken wires at flex points, chafing where the loom rubs against seat frames or bodywork, connector corrosion from moisture ingress and damage from previous repairs or improper routing. Over time insulation wears through and contacts become intermittent, producing the faults listed above.
Recommended Installation
- Disconnect Battery Before Starting Work And Wait To Allow SRS System Capacitors To Discharge.
- Remove Seat Fixing Bolts, Tilt The Seat Back And Carefully Unplug All Connectors. Label Connectors During Disassembly To Ensure Correct Reconnection.
- Avoid Pulling On Wires Directly; Unclip The Harness From Its Mounting Points And Route The New Harness Along The Original Path Using The Same Clips.
- Inspect Seat Frame And Connector Plugs For Damage Or Corrosion; Replace Damaged Clips Or Protect The Loom Against Future Abrasion.
- Tighten Seat Bolts To Manufacturer Specifications And Verify All Functions (Adjustment, Heating, Airbag/Occupancy Signals) After Reconnection.
- If The Seat Is Fitted With Airbag Connectors Or Occupancy Sensors, Consider Professional Installation To Ensure Safety Systems Remain Fully Functional.
Notes For Mechanics And Do-It-Yourself Enthusiasts
This harness is a direct-replacement style part commonly sought under the code 6545GC. When replacing, carefully compare connector shapes and pin counts to the original harness to ensure a correct fit. Proper routing and secure fixation are essential to prevent premature failure. If multiple seat functions are affected, inspect the harness thoroughly before replacing individual components.
