Description
Right front window regulator mechanism for Peugeot 308 first series. Motor can be purchased separately.
Product Overview
High-quality replacement right front window regulator mechanism designed for Peugeot 308 first generation. This regulator restores reliable, smooth movement of the front right window and is suitable for professional workshops and DIY mechanics. Commonly searched by part numbers 9658926980 and 9675466080, it is a direct-fit unit that replaces worn or damaged regulators and helps eliminate rattles, slow window travel or complete window drop.
Key Features
- Direct replacement for Peugeot 308 First Generation (right front door)
- Durable construction with reinforced rails and cable guide (where applicable)
- Motor Sold Separately – allows reuse of existing drive motor if serviceable
- Compatible With Original Mounting Points And Fasteners For Easier Installation
Technical Information
- Manufacturer: Stellantis (Peugeot / Citroën)
- Model: Peugeot 308 First Generation (2007–2013)
- Product Codes: 9658926980, 9675466080
- Additional Numbers: 9222CV
Compatibility And Fitment
Designed for the right front door of Peugeot 308 first series. On left-hand drive vehicles this corresponds to the passenger side. Confirm fitment by matching the part numbers listed above with the unit on the vehicle. Fits hatchback and estate variants of the first generation where factory mounting points and door architecture match.
Installation Recommendations
- Always disconnect the battery before starting work to prevent accidental window movement and electrical short circuits.
- Remove interior door trim carefully to avoid breaking clips; keep all fasteners organized.
- Support the window glass before detaching the regulator — use tape or a suitable glass holder to prevent the glass from falling.
- If reusing the original motor, inspect brushes and commutator; replace the motor if performance is degraded.
- Lubricate guide rails and check rubber seals to ensure smooth operation after installation.
- After installation, cycle the window several times to check alignment and smooth travel; adjust mounting as required.
Most Common Failure Causes
- Cable Wear Or Fraying: Repeated use and contaminant ingress can fray the regulator cable, causing sticking or complete failure.
- Broken Plastic Components: Many regulators use plastic pulleys or clips that can become brittle and break over time.
- Motor Failure: The window motor can lose torque due to worn brushes or internal wear; motors are available separately.
- Corrosion And Water Ingress: Moisture inside the door can corrode tracks and fasteners, increasing friction and wear.
- Misalignment Or Glass Jamming: Bent guides or misaligned glass increase load on the regulator and accelerate failure.
Why Choose This Part
This right front window regulator mechanism is intended for technicians and experienced DIYers seeking an OE-compatible repair solution for Peugeot 308 first generation. With direct-fit mounting and clear part-number identification, it simplifies replacement and reduces workshop time. Purchasing the regulator separately from the motor gives flexibility to reuse a serviceable motor or upgrade when needed.
Notes
Motor Is Not Included Unless Stated. Verify part numbers 9658926980 and 9675466080 against the unit being replaced to ensure correct fitment.
