Description
Door handle for left rear and right front and rear doors for Citroën and Peugeot vehicles. Color KGZ – Inari Blue. We have various colors in stock.
High-quality exterior door handle designed for reliable fitment on a wide range of Citroën and Peugeot models. Built to restore correct operation of the door latch and central locking mechanism, this handle matches OE mounting points and paint code KGZ (Inari Blue) for a factory‑look finish. Ideal for professional technicians and DIY enthusiasts who search by part number (9101GH / KGZD) to ensure fast identification and installation.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën Berlingo III, Citroën C4 Picasso, Peugeot 2008, Peugeot 207, Peugeot 308, Peugeot Partner III, Citroën Jumpy III, Peugeot Expert III (check door position: left rear; right front and right rear)
- Product Codes: 9101GH, KGZD
- Additional Numbers: Colour code KGZ (Inari Blue)
Fitment And Purpose
This handle is intended for exterior mounting on specified Citroën and Peugeot doors (left rear, right front and right rear). It provides the mechanical interface between the user and the door latch assembly, transferring pull/push motion to the internal latch rod and engaging the central locking actuator when applicable.
Function And Common Failure Causes
The primary function is to operate the door latch and allow entry/egress while integrating with the vehicle’s locking system. Common causes of failure include mechanical wear of plastic components, broken internal pivots or clips, corrosion and seizing of the linkage, impact damage (door collisions), and UV or environmental degradation of plastic finishes. Water ingress and freezing can also bind moving parts and accelerate breakage.
Replacement Procedure
- Required Tools: trim removal tool, Torx/Phillips screwdriver set, socket set, long‑nose pliers, and a flashlight.
- Basic Steps: Remove interior door trim carefully to access the handle linkage and fasteners; disconnect electrical connectors for central locking or courtesy switches if present; unhook linkage rods and remove handle mounting screws or clips from the outside; install new handle by reversing the procedure, ensuring rods and clips are fully seated and connectors are secure.
- Testing: Before refitting the door trim, operate the handle from inside and outside and cycle the central locking to confirm smooth operation and correct alignment.
- Safety Note: Take care around side airbag areas when removing trim. Follow manufacturer guidance for panel removal and handle electrical connections.
Installation Recommendations
- Replace any damaged or brittle trim clips and linkage clips during installation to prevent future rattles or failures.
- Lightly lubricate moving metal-to-metal joints with an appropriate grease to reduce wear; avoid contaminating painted surfaces.
- Check alignment of the handle with the door latch striker to prevent premature wear or binding.
- If the vehicle uses electronic locking microswitches integrated in the handle, verify electrical continuity and central locking operation after fitment.
- Store and handle painted parts carefully to avoid scratches; colour KGZ corresponds to Inari Blue—final colour match should be confirmed visually.
Reason Why The Part Most Often Fails
Door handles most frequently fail due to mechanical wear of plastic pivots and clips, corrosion or deformation of linkage rods, accidental impact (door hits), and long‑term exposure to UV and weather. Repeated forceful operation and frozen conditions can trigger sudden breakage of internal components.
