Description
Tailgate Handle With Microswitch For Citroën C3 Pluriel And Peugeot 307 Hatchback. Color ETS – Grey Cendré Paint.
Product Overview
High-quality replacement tailgate handle with integrated microswitch, designed for Citroën C3 Pluriel and Peugeot 307 Hatchback. Frequently searched under product code 8726N1 (ETSC/ETS), this unit restores reliable boot opening and correct boot-open signal to the vehicle’s locking system. Suitable for mechanics and competent DIYers who need a direct-fit part that matches the ETS Grey Cendré finish.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën C3 Pluriel; Peugeot 307 Hatchback
- Product Codes: 8726N1
- Additional Numbers: ETSC; ETS
Function And Fitment
This handle replaces the exterior tailgate release and contains an integrated microswitch that signals the boot-open/closed status to the vehicle’s central locking and safety systems. It is a direct replacement unit intended to fit the original mounting points on the tailgate. The painted ETS Grey Cendré finish provides a near-original look for matching tailgates.
Replacement Procedure
Typical replacement steps: Remove the inner tailgate trim to access the handle fasteners. Disconnect the electrical connector for the microswitch, remove the mounting screws or clips securing the handle, and withdraw the old unit. Fit the new handle, reconnect the microswitch connector and secure all fasteners. Reinstall the trim and test the handle operation and locking signals. Always disconnect the battery before starting work on electrical components to avoid short circuits or accidental activation.
Installation Recommendations
- Use proper trim tools to avoid damaging interior panels.
- Protect painted surfaces during installation and avoid levering on the painted shell.
- Check and, if necessary, replace brittle plastic clips or damaged seals when reassembling.
- Apply a light dielectric grease to the electrical connector to reduce the risk of corrosion.
- After installation, Verify Boot Latch Function: Ensure the boot locks and releases correctly and that the boot-open indicator or central locking responds as expected.
Why This Part Most Commonly Fails
- Plastic Fatigue Or Breakage: Repeated use and mechanical stress can fracture the plastic lever or mountings.
- Water Ingress And Corrosion: Moisture can corrode the microswitch or connector, causing intermittent or permanent electrical failure.
- Impact Damage: Rear impacts or heavy loads on the tailgate can deform or break the handle assembly.
- Connector Or Wiring Damage: Abrasion, pin corrosion, or connector failure can interrupt the microswitch signal.
Search And Order Tip: Many technicians and DIY enthusiasts locate this item by product code 8726N1 or by the ETS/ETSC identifiers. The handle is intended as a direct-fit replacement for the listed models and restores both mechanical operation and electrical boot status signaling.
