Description
Fuel filler flap/cover for Peugeot 206 and 206+. Aluminium effect – used part, shows signs of use.
Product Overview
This fuel filler flap/cover is a direct-fit replacement designed for Peugeot 206 and Peugeot 206+. With an aluminium-effect finish, this used part is ideal for mechanics and DIY enthusiasts looking for an economical and visually consistent repair. Commonly searched by product numbers 1508F6, 962669 or 9642555380, it restores the exterior appearance and protects the fuel filler from dirt and moisture.
Features And Benefits
- Direct-fit design for easy installation on Peugeot 206 and 206+ models.
- Aluminium-effect surface for a neat, factory-like appearance.
- Cost-effective alternative to full new-body parts—suitable for quick exterior repairs.
- Used part inspected for functional condition; may show cosmetic marks consistent with prior use.
- Searchable by OEM/reference numbers to speed up part identification and ordering.
Compatibility
Fits the following models:
- Peugeot 206
- Peugeot 206+
Replacement Procedure
Replacing the fuel filler flap is a straightforward job for a workshop or experienced DIYer. Typical steps:
- Open the fuel flap and locate retaining screws, clips or the hinge pin. Remove any visible fasteners (Torx/Phillips depending on vehicle version) and trim clips as required.
- Carefully disengage the hinge and release the latch mechanism from the inside if accessible. Keep small clips and screws for reuse where possible.
- Fit the replacement flap by aligning the hinge and latch, then secure fasteners without over-tightening. Check even gaps and closing action.
- Test opening/closing several times to ensure smooth operation and correct alignment. Replace broken clips or worn hinge components during installation for lasting fitment.
Maintenance Tips
- Lubricate hinge pivot with light grease to prevent creaking and wear.
- Inspect plastic clips and latches for cracking; replace damaged fasteners to avoid rattles or loss of the flap.
- When painting or colour-matching, mask surrounding areas to avoid overspray and ensure a factory-like finish.
Most Common Failure Reasons
- Impact damage from minor collisions or refuelling area knocks, causing dents or broken hinges.
- Plastic clip and hinge wear leading to loose or misaligned flap.
- Corrosion on metal parts or internal latch components, especially in salted-road climates.
- Cosmetic ageing and paint fading from sun exposure; aluminium-effect finish may show scratches.
Technical Information
- Manufacturer: Peugeot / Stellantis
- Model: Peugeot 206; Peugeot 206+
- Product Codes: 1508F6; 962669
- Additional Numbers: 9642555380
Installation Recommendation
Before installation, compare the replacement flap to the original to confirm hinge type and mounting points. Replace any worn clips or screws and clean mating surfaces to ensure proper seating. Align the flap carefully before final tightening to avoid paint damage. If the latch mechanism shows wear, replace or refurbish it at the same time to prevent premature failure.
Why This Part Fails Most Often
Failures are usually caused by external impacts, degraded plastic clips or worn hinge pivots. Environmental factors such as moisture, road salt and UV exposure accelerate wear and can cause corrosion or cosmetic deterioration of the aluminium-effect finish. Proper inspection and replacing degraded mounting hardware during installation significantly reduce the chance of repeat failures.
