Description
Left Rear Fender Lamp For Peugeot 607 – ORIGINAL. Without Bulb Holders, These Can Be Ordered Under Code 6534GS. Driver Side.
Product Overview
High-quality left rear fender lamp designed for Peugeot 607. This original equipment (OE) replacement restores rear lighting functions and exterior appearance after damage or wear. The unit replaces the lamp assembly on the driver side and is supplied without bulb holders (socket), which are available separately under code 6534GS. Ideal for professional workshops and DIY mechanics looking for a direct-fit solution that matches factory specifications.
Compatibility
Fits: Peugeot 607 (Driver Side, Left Rear Fender). Commonly used on models produced during the 607 production run. Verify physical fitment and connector type before installation.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 607
- Product Codes: 6350N1
- Other Numbers: 6350N1 NFP, 6534GS (Bulb Holder / Socket)
Installation
Replacement is straightforward for a trained mechanic and can be performed with basic tools. Typical procedure:
- Switch ignition off and remove any interior trim panels in the trunk/boot to access the lamp mounting screws.
- Unscrew retaining bolts and carefully pull the lamp assembly outwards to gain access to the electrical connector.
- Disconnect the lamp connector by releasing the locking tab and remove the assembly from the vehicle.
- If required, fit the bulb holders (order code 6534GS) into the new lamp and install bulbs of the correct specification.
- Reconnect the electrical connector, position the lamp, tighten mounting bolts to manufacturer torque, refit interior trim and test all light functions (tail, stop, indicator, reverse as applicable).
Installation Recommendations
- Handle Lens Carefully: Avoid scratching the lens during removal and installation.
- Check Connectors: Inspect electrical connectors and wiring for corrosion or damage; replace bulb holders if sockets are corroded.
- Use Correct Bulbs: Install bulbs of the correct type and rating; insecure or incorrect bulbs can cause poor contact or damage.
- Sealing: Ensure sealing surfaces are clean and the lamp sits flush to prevent water ingress; replace any damaged gaskets.
- Final Check: Verify all light functions on vehicle before finishing the job.
Common Failure Reasons
- Water Ingress And Condensation: Damaged seals or cracked lens allow moisture to enter, causing corrosion and electrical faults.
- Socket Corrosion Or Loose Contacts: Over time bulb holders and connectors corrode, leading to intermittent or non-functioning lights.
- Physical Damage: Impacts or parking knocks commonly crack the lens or break mounting tabs.
- Aging And UV Damage: Prolonged sun exposure can yellow or weaken the plastic lens and seals.
Why Choose This Part
This original left rear fender lamp offers a direct-fit, factory-matching replacement that preserves vehicle appearance and lighting performance. It is a practical choice for body repairs, insurance replacements, or restoring a worn lamp assembly. Order the lamp and the matching bulb holders (code 6534GS) to complete the installation quickly and reliably.
