Description
Left rear tail light for PEUGEOT 307 SW up to 2005. Without bulb holders; sockets can be purchased separately. Driver side.
Product Overview
This left rear tail light is a direct-fit replacement for the Peugeot 307 SW (estate) models produced up to 2005. Designed for mechanics and DIY car owners, the unit restores rear lighting functions and exterior appearance after damage or wear. Frequently searched by product code, this lamp is referenced with code 6350Q6.
Key Benefits
- Direct replacement for Driver Side Left Rear position on Peugeot 307 SW (up to 2005).
- Restores Rear Lighting Performance And Road Safety.
- Suitable For Professional Workshops And Home Mechanics — Easy To Fit With Basic Tools.
How The Part Functions
This assembly serves as the rear combination lamp, providing rear position (tail), stop, and turn-signal functions; actual lamp functions depend on the vehicle wiring and bulb configuration. The lamp housing secures to the bodywork and connects to the vehicle harness via the bulb sockets/wiring. Note: Bulb holders/sockets are not included with this unit and must be purchased separately if required.
Replacement Procedure
Typical replacement steps for a Peugeot 307 SW driver-side rear lamp:
- Open The Tailgate To Access The Lamp From Inside The Boot.
- Remove Interior Trim Or Access Cover To Reach Lamp Fasteners.
- Disconnect The Electrical Connector And Remove Bulbs/Bulb Holders (If Present).
- Unscrew Mounting Screws Or Nuts Securing The Lamp Assembly.
- Carefully Pull The Lamp Out From The Body Seal And Remove The Old Unit.
- Fit The New Lamp, Ensure Proper Seal Alignment, Secure Fasteners, Reconnect Wiring And Bulbs.
- Test All Lighting Functions Before Reinstalling Interior Trim.
Installation Recommendations
- Use Correct Bulb Types As Specified In The Vehicle Manual And Ensure Proper Orientation.
- Inspect Seals And Gaskets; Replace Any Brittle Or Damaged Seals To Prevent Moisture Ingress.
- Check Wiring Connectors For Corrosion Or Loose Contacts; Clean Or Replace As Necessary.
- Tighten Fasteners Evenly To Avoid Distorting The Lamp Housing; Avoid Over-Tightening.
- After Installation, Verify All Rear Lighting Functions Are Working (Tail, Brake, Indicator, Reverse If Applicable).
Reason Why The Part Most Commonly Fails
Rear lamps on Peugeot 307 SW commonly fail due to moisture ingress through degraded seals or cracked lenses, physical damage from impacts, brittle plastic or mounting tab breakage caused by vibration and age, and corrosion of electrical contacts that leads to intermittent or failed lighting. Bulb holder deterioration is another frequent cause—remember this unit is supplied without bulb holders.
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 307 SW (up to 2005)
- Product Codes: 6350Q6
- Additional Numbers: NFP
Notes For Buyers
Part Is Intended For The Driver Side (Left) Rear Of Peugeot 307 SW Models Up To 2005. Many Customers Search By The Product Code 6350Q6, So Keep This Reference Handy When Ordering Or Comparing Parts. Bulb Holders Are Not Included With This Lamp And Must Be Purchased Separately If Required.
