Description
Left rear original lamp for Citroën Berlingo and Peugeot Partner. Without Bulb Holder; The Socket Can Be Purchased Separately. For Double-Wing Rear Doors.
Product Overview
Genuine left rear combination lamp suitable for Citroën Berlingo and Peugeot Partner models with double-wing (twin) rear doors. This original equipment lamp restores factory-fit appearance and light distribution, making it an ideal replacement for workshops and experienced DIY mechanics. The housing is supplied without the bulb holder/socket, which may be ordered separately.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Citroën Berlingo, Peugeot Partner (Double-Wing Rear Doors; Compatible With First And Second Generation Variants)
- Product Codes: 6350Z0, 6350CX
- Additional Numbers: None Available
Function And Compatibility
This left rear lamp is a combination unit that covers standard rear lighting functions used on Berlingo and Partner vehicles. Typical functions include tail/position lights, stop (brake) lights, and turn signal; some variants may also include reverse or rear fog lamp elements depending on vehicle specification. Always confirm function layout against the vehicle’s original unit number and wiring harness before installation.
Replacement Guide
- Park Vehicle Safely And Disconnect The Battery If Working On Live Circuits—Isolate Power To Avoid Short Circuits.
- Open The Rear Doors And Remove Interior Trim Panels Or Access Plugs To Reach The Lamp Fasteners.
- Unscrew The Mounting Bolts/Nuts Securing The Lamp Assembly From Inside The Boot Aperture.
- Carefully Pull The Lamp Outwards, Release Any Retaining Clips And Disconnect The Wiring Connector(s).
- Fit The New Lamp, Reconnect The Wiring Connector, Refit Fasteners And Interior Trim, Then Test All Lighting Functions.
Installation Recommendations
- Use Correct Torque For Fasteners To Avoid Cracking The Housing Or Distorting The Seal.
- Replace Bulb Holders/Sockets If Corroded Or Damaged; This Unit Is Supplied Without A Socket.
- Ensure Sealing Surfaces Are Clean And The Gasket Or Seal Is Correctly Seated To Prevent Moisture Ingress.
- Test All Functions After Installation (Position, Brake, Indicator, Reverse/Fog If Applicable).
Why This Part Commonly Fails
- Moisture Ingress: Damaged Seals Or Cracked Lens Allow Water To Enter, Causing Bulb Failure, Corrosion, Or Condensation.
- Impact Damage: Rear Bumps Or Loading Mishaps Can Crack The Lens Or Break Mounting Tabs.
- Socket Corrosion Or Wear: Bulb Holders And Contacts Can Corrode Or Degrade, Leading To Intermittent Operation.
- UV And Ageing: Prolonged Sun Exposure Causes Lens Discoloration And Seal Deterioration Over Time.
Suitable For
Citroën Berlingo I & II, Peugeot Partner I & II with double-wing (twin) rear doors. Always check product codes 6350Z0 / 6350CX against the existing unit before purchase.
Notes For Professionals And DIY Mechanics
This is an original equipment lamp intended for direct replacement of the factory unit. It is a practical choice for service workshops and skilled DIYers who handle light-unit replacement and basic wiring work. Keep replacement bulb holders and appropriate fasteners on hand to complete the job in one visit.
