Description
Left rear lamp for PEUGEOT 3008 first generation. Without bulb holders – these can be purchased separately. Driver’s side.
Description
Direct-fit left rear tail lamp designed for the first generation Peugeot 3008. This unit replaces a damaged or missing taillight assembly and restores rear lighting functions including tail, brake and indicator (depending on vehicle wiring and bulb configuration). The lamp is supplied without bulb holders/sockets; bulbs and holders must be obtained separately.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 3008 I (First Generation)
- Product Codes: 9683460880, 6350HC
- Additional Numbers: —
Compatibility
Fits Peugeot 3008 first generation models (typically 2008–2016). Left rear / driver’s side unit for left-hand drive vehicles. Always verify part numbers when replacing to ensure correct fit for specific vehicle version and facelift.
Installation Recommendations
Recommended for professional mechanics or experienced DIYers. Typical replacement steps:
- Open the tailgate and remove the interior trim panel to access the lamp mounting screws.
- Unscrew the retaining bolts (commonly Torx or metric), carefully pull the lamp slightly outwards and disconnect the electrical connector.
- Remove the lamp assembly from the body, transfer any required clips or seals to the new unit, then refit in reverse order.
- Install appropriate bulb holders and bulbs (not included) and check all lighting functions after installation.
Tools typically required: trim removal tool, Torx/metric sockets, ratchet, flat screwdriver and gloves. Switch off ignition and lights before starting; if unsure, isolate the negative battery terminal to avoid short circuits.
Common Causes Of Failure
- Impact Damage: Rear collisions or parking impacts that crack the lens or deform the housing.
- Water Ingress: Seals and gaskets can deteriorate, allowing moisture to enter and corrode contacts or cause bulb failure.
- Connector Corrosion: Oxidation or corrosion of the wiring connector can cause intermittent or complete loss of function.
- Thermal Stress And Bulb Heat: Prolonged use of incorrect bulbs or poor ventilation can damage sockets or wiring.
- Mechanical Wear: Mounting points and clips can break over time during disassembly or due to vibration.
Why Choose This Part
This left rear lamp matches OEM product codes listed above and is an appropriate replacement when restoring the rear lighting on first-generation Peugeot 3008 vehicles. Supplying the full lamp assembly (lens and housing) ensures correct fit and alignment with body trim.
Notes
Bulb holders are not included and must be purchased separately. Consult the vehicle manual for the correct bulb types and socket configurations for your specific 3008 variant.
