Description
Socket with bulb for right rear lamp Peugeot 307 3-door and 5-door. Functionality of bulbs and their supply not guaranteed. With a piece of wiring.
Product Overview
This replacement tail light socket with a short length of wiring is designed for the right rear lamp of the Peugeot 307 (3-door and 5-door, Phase 1 and Phase 2). It is offered under the reference 6351P3 and is suitable for mechanics and experienced DIYers who need a direct-fit lamp holder or a quick repair of the rear lighting harness. Typical search terms: Peugeot 307 rear lamp socket, taillight bulb holder 6351P3, right rear tail light connector, tail light wiring harness.
Technical Information
Manufacturer: Stellantis (Citroën/Peugeot)
Model: Peugeot 307 (3-Door, 5-Door; Phase 1 and Phase 2)
Product Codes: 6351P3
Other Numbers: None Known
Fitment And Function
The part serves as the bulb holder/socket for the right-hand rear lamp cluster. It secures the bulb, provides electrical contact, and connects the bulb to the vehicle wiring via the attached piece of cable. The delivered item may or may not include functioning bulbs; buyers should plan to install correctly rated replacement bulbs if necessary.
Replacement Procedure
- Park the vehicle on a level surface, switch off ignition and remove the key.
- Open the boot and remove the trim or access panel to reach the rear lamp cluster.
- Unscrew and remove the lamp assembly fasteners and gently pull the lamp out to gain access to the rear side.
- Disconnect the original socket from the bulb and unplug the connector from the vehicle harness. Note orientation and clips to ensure correct reassembly.
- Install the new socket (6351P3) by seating the bulb into the holder, connecting the wiring to the vehicle harness and securing any retaining clips.
- Refit the lamp cluster, tighten fasteners and restore interior trim. Test all light functions (stop, tail, indicator, reverse if applicable) before driving.
Installation Recommendations
- Work with the ignition off and avoid shorting contacts; disconnecting the negative battery terminal is recommended for safety when working on electrical connections.
- Use bulbs of the correct type and rating specified for the vehicle to avoid overheating or poor contact.
- Check connector pins for corrosion and clean with appropriate contact cleaner before mating connectors.
- Ensure the lamp housing sealing surfaces and gaskets are intact to prevent water ingress after reassembly.
- If a longer wiring repair is required, use automotive-grade wiring and proper crimping/soldering techniques with heat-shrink insulation.
Most Common Failure Causes
Bulb holders in rear lamp clusters typically fail due to corrosion of the contacts, water ingress into the lamp cavity, heat-related deformation from overloaded or incorrect bulbs, or mechanical damage when removing/installing the lamp. Wiring fatigue and broken connector tabs are common on older vehicles or after repeated maintenance.
Why Choose This Part
Offering a direct, practical repair solution, this socket with a short wiring tail is ideal for restoring reliable electrical contact in the right rear lamp of Peugeot 307 vehicles. It allows fast replacement without the need to replace the entire lamp assembly, saving time and cost for professional garages and competent DIY enthusiasts.
