Description
Right rear light for PEUGEOT 307 SW from 2005. Without bulb holder/socket, which can be purchased separately. Passenger side.
High-quality replacement right rear combination lamp designed for Peugeot 307 SW (estate) models from 2005. Ideal for professional garages and DIY mechanics looking for a direct-fit rear lamp to restore vehicle safety and roadworthiness. The unit is suitable for restoring tail, brake and turn-signal functions (depending on vehicle equipment) and is often searched by product numbers such as 9655768480 or 6351X2 — include these codes when searching or ordering to ensure fast identification.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 307 SW (Estate) – from 2005
- Product Codes: 9655768480, 9655768580
- Other Numbers: 6351X2, 6351X3
Function And Fitment
This rear lamp is a combination unit that provides rear position (tail), brake and turn signal lighting; some vehicle variants may also integrate reverse or rear fog lamp functions. Confirm the physical connector and bulb/socket arrangement before installation — this listing indicates the lamp is supplied without the bulb holder/socket, which must be purchased separately if required.
Replacement Procedure
Basic steps for replacing the right rear lamp (typical for Peugeot 307 SW):
- Open the tailgate and remove or fold back the inner trim panel to access the lamp fixing screws.
- Unscrew the retaining bolts or nuts securing the lamp assembly. Keep fasteners for reuse if undamaged.
- Carefully pull the lamp unit outwards and disconnect the wiring harness connector. If the lamp uses separate bulb holders, remove them from the old unit and transfer to the new unit if compatible.
- Fit the new lamp, reconnect the wiring, check that the seal sits correctly to prevent water ingress, and secure with the original fasteners.
- Test all light functions (tail, brake, indicators, reverse/fog where applicable) before reassembling the trim.
Mounting Recommendations
- Work With Ignition Off And Lights Switched Off. Protect Painted Surfaces With Tape Or Soft Cloth To Avoid Scratches.
- Use Appropriate Tools: Ratchet or Torx depending on fasteners, trim pryer, and dielectric grease for electrical contacts.
- Replace Bulb Holders If Not Included: This unit is supplied without the bulb holder/socket — purchase the correct holder if your vehicle requires it.
- Ensure Seals Are Intact: Check and, if necessary, replace the rubber gasket to prevent moisture entering the lamp housing.
- After Installation: Verify all lamp functions and check alignment and closure of the tailgate to avoid pressure on the lamp housing.
Why The Part Most Commonly Fails
Rear lamps typically fail due to physical damage from collisions or impacts, water ingress through degraded seals causing corrosion of contacts or bulbs, and cracked lenses from stone chips or UV aging. Electrical connector corrosion and broken bulb holders are also common causes, especially on older vehicles. Regular inspection of seals and connectors and prompt repair after minor impacts will extend service life.
Notes For Mechanics And DIYers
Search By Product Code For Fast Identification: Many customers locate this lamp using OEM numbers (9655768480 / 9655768580) or internal codes (6351X2 / 6351X3). Suitable for fitting in professional workshops as well as by experienced home mechanics. If the original bulb holder is missing on the supplied unit, order the matching socket to complete installation.
Compatibility Reminder
Designed For Peugeot 307 SW estate models from 2005 onward. Match the lamp shape, mounting points and connector type with the vehicle before fitting to ensure correct fitment.
