Description
Right Exterior Mirror For PEUGEOT 207. Electrically Adjustable, Heated, Temperature Sensor. 9 (4+5) Pin. Color EZRC – Paint Gray Aluminium. Slightly Scratched, See Photo.
This used right exterior mirror is a direct-fit replacement for Peugeot 207 vehicles and is ideal for professional mechanics and experienced DIYers. It combines electric adjustment, heating and a temperature sensor to ensure clear visibility in cold and wet conditions. Commonly searched by product codes 96806501XT and 8149ZH, and by paint code EZRC, this unit saves time on bodywork matching while restoring full mirror functionality.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 207
- Product Codes: 96806501XT, 8149ZH
- Additional Numbers: EZRC (Paint: Gray Aluminium); 9-Pin Connector (4+5)
Compatibility Notes
Fits Peugeot 207 models equipped with a 9-pin (4+5) connector and heated electric mirror functionality. Verify match to your door wiring and connector type before installation. This mirror is for the right-hand (passenger) side.
Function And Failure Causes
The mirror provides electrically controlled mirror positioning, heated element for demisting/defrosting and a temperature sensor used by vehicle climate systems. Most common causes of failure:
- Impact Damage: Collisions or knocks are the leading cause of broken glass, cracked housings or snapped folding mechanisms.
- Water Ingress And Corrosion: Moisture can corrode connector pins and motor contacts, causing intermittent or permanent failure.
- Wear Of Electric Motor/Actuators: Frequent adjustment over years can wear the gear trains or motors.
- Heater Or Sensor Faults: Heating element or temperature sensor can fail, reducing demist performance.
Replacement Procedure
- Disconnect Battery: Always disconnect the negative battery terminal before starting work to avoid short circuits.
- Remove Interior Door Trim: Carefully remove door trim or triangular trim cover to access mirror mounting bolts and wiring harness.
- Support The Mirror: Hold the mirror from outside while loosening fasteners to prevent it falling and damaging the door or glass.
- Disconnect Electrical Connector: Unplug the 9-pin connector (4+5) and any additional plugs for heating or sensors.
- Unscrew Mounting Bolts: Remove the retaining nuts/bolts and withdraw the mirror assembly from the door.
- Install Replacement: Position the new mirror, secure mounting bolts to manufacturer torque, reconnect the electrical connector and reseal any gaskets.
- Test All Functions: Reconnect the battery and verify electric adjustment, heating and sensor signals are functioning before reassembling trim.
Installation Recommendations
- Use Proper Tools: Torx or socket sets and trim removal tools reduce the risk of damage to fasteners and panels.
- Check Connector Condition: Inspect and clean connector pins; replace if corroded to ensure reliable electrical contact.
- Align Mirror Correctly: Set mirror position and check that folding mechanism (if present) operates smoothly.
- Follow Manufacturer Torque Specs: Tighten mounting bolts to the correct torque to avoid vibration or damage.
Why Choose This Part
This unit offers a cost-effective solution to restore full mirror functionality on Peugeot 207 vehicles without the delay of paint-matching or long lead times. The included heating and temperature sensor maintain safety and comfort in cold conditions. Slight cosmetic wear is shown in photos but does not affect mechanical or electrical performance when installed correctly.
