Description
Right headlight washer nozzle with cover and hose for Peugeot 308 T7. Cover color KTV – Black Pearl Nera paint.
Product Overview
This right-hand headlamp washer nozzle (washer jet) with cover and connecting hose is designed for Peugeot 308 T7 vehicles equipped with a headlight cleaning system. The unit restores proper washer spray direction and pattern to ensure clear illumination and safe night driving. Ideal for professional workshops and experienced DIYers, the part matches original fitment and finish for seamless replacement.
Key Benefits
- Direct fit for Peugeot 308 T7 front right headlamp washer system.
- Includes protective cover and pre-attached hose for faster installation.
- Replacement part numbers commonly used in searches (6438Y8, 6438Z0, 6439H8, 6433C4).
- Painted cover in Black Pearl Nera (KTV) for factory appearance.
- Restores correct spray pattern to maintain headlight performance and visibility.
How It Works
The nozzle connects to the vehicle’s washer fluid circuit and is actuated when the headlight wash cycle is initiated. It delivers a targeted jet of fluid to the headlamp lens to remove dirt, salt, and road film. The protective cover conceals the nozzle when retracted and matches the vehicle’s bumper finish.
Replacement Guide
Basic steps for replacing the right headlight washer nozzle (recommended for trained technicians or competent DIYers):
- Park the vehicle on a level surface and secure it. If required for access, remove the wheel arch liner or lower bumper panel following manufacturer instructions.
- Locate the washer nozzle assembly on the front right side. Remove the retaining clips or screws securing the cover/nozzle and carefully disconnect the washer hose.
- Remove the old nozzle and fit the new nozzle with its hose. Ensure the hose connection is secure and free of kinks.
- Reinstall the cover, secure all fasteners, and re-fit any removed trim or liners.
- Operate the headlight wash system to verify spray pattern, alignment, and for leaks. Adjust nozzle alignment if required.
Installation Recommendations
- Use suitable trim tools to avoid damaging bumper paint and clips.
- Inspect the washer hose for cracks or brittleness and replace if necessary.
- Clean mating surfaces of dirt and old sealant before assembly to prevent leaks.
- Test the system after installation at low pressure, then run a full cycle to confirm proper operation.
- When working near electrical connectors or sensors, follow standard workshop safety procedures and secure any loose wiring.
Why The Part Fails
- Impact Damage: Front-end impacts or stone strikes can crack the nozzle or cover.
- Blockage: Dirt, paint overspray, or frozen washer fluid can clog the nozzle tip and change spray pattern.
- Ageing And Weathering: Hoses and plastic components become brittle over time, leading to leaks or detachment.
- Ice Damage: In cold climates, trapped water that freezes can deform or break the nozzle and surrounding components.
Technical Information
- Manufacturer: Stellantis (Peugeot)
- Model: Peugeot 308 T7
- Product Codes: 6438Y8, 6438Z0, 6439H8, 6433C4
- Additional Numbers: KTVD; Cover Color: KTV – Black Pearl Nera
Compatibility And Notes
Fits right-hand (passenger side on left-hand drive vehicles) headlamp washer application on Peugeot 308 T7 models equipped with factory headlamp washers. When searching, customers often use one of the product codes listed above (e.g., 6438Y8 or 6438Z0) — include these codes in listings to improve findability.
Who Should Install
Recommended for auto technicians and experienced DIY enthusiasts. If the washer system shows additional symptoms (no fluid delivery, pump noise, multiple clogged nozzles), further diagnosis of the washer pump, lines, and reservoirs may be required.
