Description
Right exterior mirror for CITROËN Xsara Picasso, electrically operated and folding, heated, with temperature sensor. Color KSD – Paint Green Lonchamp. Square 9‑pin connector. Passenger side.
Product Overview
This replacement right (passenger side) exterior mirror is designed for Citroën Xsara Picasso vehicles and offers electrically adjustable mirror glass, electric folding mechanism and integrated heating with a temperature sensor. The unit’s original paint code is KSD (Green Lonchamp), and it uses a square 9‑pin electrical connector. Ideal for professional workshops and experienced DIY mechanics looking to restore full mirror functionality after electrical faults or physical damage.
Features And Function
- Electric Adjustment: Motorized mirror glass movement for Precise Positioning.
- Electric Folding: Power fold feature for parking in tight spaces and protection against impacts.
- Heated Glass: Integrated heating element to remove fog and ice quickly.
- Temperature Sensor: Supports climate/defogging logic where fitted.
- Connector: Square 9‑pin plug for direct replacement without rewiring on compatible vehicles.
- Finish: Painted KSD Green Lonchamp to match original bodywork where applicable.
Replacement Procedure
Typical replacement steps for a mechanically competent technician or experienced DIYer:
- Remove the interior door trim panel or triangular trim cover to access the mirror mounting area.
- Support the mirror from the outside and disconnect the 9‑pin connector inside the door.
- Unscrew the mirror mounting nuts/bolts (usually three) while holding the mirror in place.
- Remove the old mirror assembly and transfer any trim caps or mounting plates if required.
- Fit the replacement mirror, hand‑start fasteners, then torque to the vehicle manufacturer’s specification.
- Reconnect the electrical connector and verify all functions: adjustment, folding and heating. Refit interior trim.
- Test drive to confirm secure fit and full operation.
Always follow the vehicle manufacturer’s instructions and recommended torque values when available.
Technical Information
- Manufacturer: Stellantis / Citroën
- Model: Citroën Xsara Picasso (Passenger Side)
- Product Codes: 96461533XT, 8149NP, 8149FQ
- Additional Numbers: KSD, NFP
- Connector: Square 9‑pin
- Color Code: KSD (Green Lonchamp)
Mounting Recommendations
- Work On A Cold Engine: Disconnecting the battery is recommended when working on electrically powered mirrors to avoid accidental short circuits—observe safety precautions for electrical systems.
- Use Proper Tools: Support the mirror during removal to prevent dropping and damaging the painted surface or glass.
- Check Connector Condition: Inspect the 9‑pin connector and wiring for corrosion or bent pins; repair any damaged wiring before installation.
- Tightening: Fasten mirror mounting hardware to the manufacturer’s torque specification to avoid leaks or vibration.
- Function Test: After installation, verify adjustment, folding and heating functions before reassembling interior trim.
Why This Part Fails Most Often
Common causes of mirror failure on Xsara Picasso models include:
- Mechanical Wear: Small electric motors and gearbox components wear over time, causing slow or incomplete adjustment.
- Water Ingress And Corrosion: Door sealing failures or cracked housings allow moisture to reach connectors and motors, leading to corrosion and electrical faults.
- Impact Damage: Collisions or knocks can crack the glass, break the housing or shear off mounting studs.
- Wiring And Connector Faults: Bent pins, broken wires at the harness entry point, or corroded connectors interrupt power to motors and heating elements.
- Broken Clips Or Hinges: Plastic folding mechanism components become brittle with age and may fail, preventing secure stowage or movement.
Compatibility And Notes
This mirror assembly is supplied with OEM‑referenced part numbers and paint code for direct replacement on compatible Citroën Xsara Picasso vehicles. Many customers locate this part by reference numbers such as 96461533XT or 8149NP. Ensure the connector type (square 9‑pin) and passenger side orientation match your vehicle before installation.
