Description
Right rear tail light for PEUGEOT 107 up to 2012. Without bulb holders; the bulb sockets can be purchased separately. Can be used on Citroën C1. Passenger side.
Upgrade your workshop inventory with a direct-fit Right Rear Tail Light for Peugeot 107 (up to 2012) — a practical replacement part frequently searched by part number 6351X6. Ideal for professional mechanics and DIY enthusiasts, this rear lamp restores rear visibility, signaling and brake-light functions with OE-style fitment. It is supplied without bulb holders, allowing you to choose the appropriate lamp sockets and bulbs for the vehicle and local regulations.
- Direct Fit Replacement For Peugeot 107 And Compatible With Citroën C1
- Passenger Side (Right Rear) Tail Light Assembly
- Supplied Without Bulb Holders — Sockets And Bulbs Available Separately
- Part Number Frequently Used In Searches: 6351X6
How To Replace
Basic replacement steps for a tail lamp on Peugeot 107 / Citroën C1:
- Open The Tailgate And Remove Interior Trim To Access The Lamp Retaining Nuts.
- Unscrew The Retaining Nuts Or Bolts While Supporting The Lamp To Prevent It Dropping.
- Disconnect The Electrical Connector And Remove The Old Lamp Assembly.
- Install The New Lamp, Connect The Wiring, And Secure The Fasteners.
- Fit Bulb Holders And Bulbs If Required, Test All Light Functions (Rear Position, Brake, Indicator, Reverse If Applicable).
- Reassemble Interior Trim And Verify Proper Alignment And Sealing.
Technical Information
- Manufacturer: Stellantis / Citroën / Peugeot
- Model: Peugeot 107 (to 2012); Compatible With Citroën C1
- Product Codes: 6351X6
- Additional Numbers: Not Specified
Installation Recommendations
- Always Disconnect The Battery Before Working On Electrical Components To Avoid Short Circuits.
- Check Condition Of Wiring Harness And Connector Pins For Corrosion Or Damage And Clean Or Replace As Needed.
- Replace Bulb Holders If They Show Signs Of Wear Or Heat Damage; Ensure Correct Bulb Types And Ratings Are Used.
- Verify Lamp Sealing And Body Gaskets To Prevent Water Ingress; Apply Sealant Only If Recommended By Manufacturer.
- After Installation, Test All Functions (Tail, Brake, Indicator, Reverse) And Check For Correct Aiming/Alignment.
Why This Part Most Commonly Fails
- Impact Damage From Minor Collisions Or Parking Scrapes Causing Cracked Lens Or Broken Mounting Tabs.
- Water Ingress Or Condensation Leading To Corrosion Of Sockets, Connectors Or Internal Reflectors.
- Degraded Seals Or Gaskets Allowing Moisture To Enter Over Time.
- Thermal Stress And Vibration Causing Bulb Holder Or Connector Wear.
- Accidental Over-Tightening Or Improper Installation Breaking Mounting Points.
For mechanics and self-repairers, searching by part number 6351X6 or by vehicle model (Peugeot 107 / Citroën C1) speeds up finding the correct replacement. Inspect the mounting points and electrical connections when servicing to avoid repeat failures.
