Description
Socket for right rear lamp with wiring for PEUGEOT 206 3/5-door from production date 7/2003. Not rusty, fully functional. Functionality of the bulbs themselves not guaranteed. Located behind the passenger seat.
This replacement right rear lamp socket with attached wiring harness is designed for Peugeot 206 (3- and 5-door) models produced from July 2003. Ideal for mechanics and DIY car owners who need a direct-fit tail light bulb holder (right side, passenger) when facing intermittent lighting, poor contact, or damaged connectors. Supplied as a complete socket and cable assembly, it restores reliable electrical connection for stop, tail and indicator bulbs without modifying the original lamp unit.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 206 (3/5-door), Right Rear Lamp Socket
- Product Codes: 6351S0
- Other Numbers: No additional OEM numbers provided
Function
The socket secures and electrically connects the rear light bulbs (tail, brake and indicator) to the vehicle wiring. It provides mechanical retention, contact pins for power and ground, and an insulated cable section routed into the vehicle harness.
How To Replace
Replacement is straightforward for an experienced mechanic or competent DIYer. Typical procedure:
- Park on a level surface and remove ignition key.
- Disconnect the battery before starting any electrical work to avoid short circuits.
- Remove interior trim or trunk lining on the right/rear passenger side to access the lamp carrier.
- Unclip the lamp cluster and withdraw it slightly to reach the bulb holder.
- Release retaining clips on the old socket, unplug the connector and remove the bulb(s).
- Install the new socket: fit bulbs into the new holder, connect to the vehicle harness and secure retaining clips.
- Test all lamp functions (tail, brake, indicator) before refitting trim and final assembly.
Estimated time: 20–45 minutes depending on access and vehicle trim. Tools commonly needed: flat and Phillips screwdrivers, trim removal tool, pliers, and a small socket set.
Installation Recommendations
- Always Disconnect The Battery Prior To Work On The Electrical System.
- Inspect The Lamp Gasket And Lamp Housing For Water Ingress; Replace Seals If Damaged To Prevent Future Corrosion.
- Check Relevant Fuses And Bulb Condition When Replacing The Socket To Ensure Proper Operation.
- Ensure Wiring Is Routed Without Sharp Bends Or Pinch Points And Secure With Clips Or Ties.
Most Common Causes Of Failure
- Corrosion Of Contact Pins Due To Moisture Ingress, Leading To Poor Contact Or Intermittent Lighting.
- Heat Damage From Overheated Bulbs Causing Plastic Melting Or Deformation.
- Mechanical Wear Or Breakage Of Retaining Clips From Repeated Removal.
- Wiring Chafing Or Connector Damage After Body Repairs Or Impact.
Why Choose This Part
Direct-fit design matched to the original Peugeot 206 right rear lamp assembly provides reliable reconnection of tail, brake and indicator circuits. Useful spare for workshops and DIY enthusiasts seeking to eliminate flicker, open circuits or loose bulb holders without replacing the entire lamp cluster.
