Description
Left rear original lamp for Citroën Berlingo and Peugeot Partner. Without bulb sockets; the socket can be purchased separately. For two-leaf rear doors.
This left rear tail lamp is an OEM-quality replacement designed specifically for Citroën Berlingo and Peugeot Partner models equipped with two-leaf rear doors. Supplied without bulb sockets, the unit allows workshops and DIY enthusiasts to reuse existing holders or install new sockets as required. Built to restore correct light signal performance and exterior appearance after impact damage, cracking, or long-term weathering. Commonly searched by part numbers 6350Z0 and 6350CX — ideal for mechanics and self-repairers who search by product code.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Citroën Berlingo (I & II), Peugeot Partner (I & II) — Vehicles With Two-Leaf Tailgate
- Product Codes: 6350Z0, 6350CX
- Other Numbers: Not Available
Installation Recommendations
- Always disconnect the battery before starting work to avoid short circuits and accidental activation.
- Open the two-leaf rear doors and remove the interior trim panel or access cover to reach the mounting screws.
- Remove fixing screws/bolts (typically Phillips/Torx), unclip the lamp from its mounting points and disconnect the wiring harness.
- Transfer existing bulb sockets if usable, or fit new sockets (unit supplied without sockets). Check bulb types and replace bulbs if necessary.
- Inspect and renew the sealing gasket if brittle or damaged to prevent water ingress. Ensure lamp sits flush and fasteners are torqued to manufacturer recommendations.
- After installation, reconnect the battery and test all light functions (tail, brake, indicator, reverse where applicable) before refitting trim.
- Recommended Tools: Trim removal tools, Torx/Phillips drivers, socket set, dielectric grease for connectors.
Why This Part Fails Most Often
- Moisture Ingress: Cracked lens or degraded seals allow water to enter, causing corrosion and short circuits.
- Impact Damage: Rear-end collisions or heavy closing of rear doors can break the housing or mounting tabs.
- Connector And Socket Wear: Corroded contacts or brittle bulb sockets lead to intermittent operation or total failure.
- UV And Ageing: Prolonged sun exposure can fog or crack the lens and weaken retention clips.
- Improper Installation: Over-tightening or misalignment can stress mounting points, causing premature failure.
Order by part codes 6350Z0 or 6350CX to ensure quick identification and fitment. Suitable for professional garages and competent DIY mechanics who require an OEM-standard left rear lamp for Berlingo and Partner models.
