Description
Right Front Fog Light for Peugeot 308 T7
This right front fog light is designed for Peugeot 308 T7 vehicles and carries the manufacturer references 9680498880 and 6206F0. The complete assembly restores low-beam visibility in poor weather, meets original equipment fitment standards and is commonly searched by part number for fast identification. Ideal for professional workshops and experienced DIYers looking for a direct-fit replacement fog lamp that matches factory mounting points and connector types.
Function and Application
The fog light improves lateral and low-angle illumination in fog, heavy rain or snow, making close-range obstacles and road edges easier to see. It is intended as the Right (Passenger) Side Front Fog Lamp for Peugeot 308 (T7). This assembly is compatible with the factory bumper cutout and electrical connector used on the stated model series. Use the product codes below when searching for correct fitment.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 308 T7
- Product Codes: 9680498880, 6206F0
- Additional Numbers: 6206F0 (Manufacturer Alternative Code)
Replacement Procedure
Typical replacement is straightforward for a trained technician. Common steps:
- Switch off ignition and, if required for easier access, disconnect the negative battery terminal.
- Access the fog lamp via the wheel arch liner or by removing the front bumper, depending on the vehicle specification.
- Unplug the electrical connector from the lamp and remove retaining screws or clips holding the assembly.
- Extract the old unit, transfer any required brackets or trim, and fit the new assembly ensuring correct orientation and sealing surfaces.
- Reconnect the electrical connector, test lamp function, and confirm beam alignment and secure mounting.
Why Faults Commonly Occur
Fog lamps most often fail due to water ingress and seal deterioration, corrosion of electrical connectors, impact damage from road debris, or broken mounting tabs from minor collisions. Bulb-containing assemblies may also fail due to bulb burnout or socket corrosion. In regions with heavy road salt or frequent moisture cycles, seal failure and corrosion can shorten service life. With normal use, assemblies can last many years, but exposure and mechanical damage accelerate wear.
Recommendations For Mounting
- Inspect Seals: Check and, if necessary, renew rubber seals to prevent moisture ingress.
- Connector Care: Clean connector pins and apply dielectric grease to reduce corrosion risk.
- Secure Fastening: Use correct clips/screws and avoid overtightening to prevent cracked housings or stripped threads.
- Alignment Check: After installation, verify lamp aim to ensure correct beam pattern and compliance with local regulations.
- Workshop Tools: Some vehicles require bumper removal—have suitable lifting/support equipment and trim tools ready.
Search and order by the product codes 9680498880 or 6206F0 to quickly locate the correct right front fog light for Peugeot 308 T7 vehicles. Suitable for professional garages and experienced DIY enthusiasts who follow safe working procedures.
