Description
Spare wheel winch for Peugeot 307 and 308
High-quality spare wheel winch compatible with Peugeot 307 and Peugeot 308 models. Supplied with manufacturer reference numbers to help fast lookup (OE: 9659556977, 673504). Designed for mechanics and competent DIY enthusiasts who need a reliable replacement for a rusted or worn hoist mechanism holding the underbody spare wheel. Commonly searched under the part numbers listed above — including these codes in your listing increases findability in search engines and speeds up workshop procurement.
Technical Information
- Manufacturer: Stellantis (Peugeot / Citroën)
- Model: Peugeot 307, Peugeot 308
- Product Codes: 9659556977, 673504
- Other Numbers: Workshop category – Spare Wheel Brackets / Body
Function And Application
The winch assembly secures and lowers the spare wheel located under the rear of the vehicle. It consists of a drum, steel cable and mounting bracket that allow controlled lowering and raising of the spare tyre using the vehicle’s release tool. This part is a direct-fit replacement for the specified Peugeot models and restores original function when the cable, drum or mounting points are corroded or damaged.
Replacement Procedure
- Park the vehicle on level ground and engage the handbrake. Use wheel chocks for extra safety.
- Remove interior trunk trim or underfloor cover to access the spare wheel winch cable release point according to the vehicle layout.
- Use the correct release tool (or supplied key) to lower the spare wheel until it is supported; place a jack or support under the wheel to prevent it from dropping suddenly.
- Unbolt the winch mounting points. Keep track of fasteners and any spacers or washers.
- Disconnect the cable from the drum and remove the winch assembly. Inspect surrounding components and mounting bracket for corrosion or damage.
- Install the replacement winch in reverse order: fit the drum, route the cable as original, secure fasteners to the manufacturer’s guidelines and stow the release tool correctly.
- Test operation by lowering and raising the spare wheel several times to confirm smooth function and correct cable winding. Trim or crimp any excess cable only if required and safe to do so.
Installation Recommendations
- Perform installation with the wheel supported to avoid sudden drops.
- Use penetrating oil on corroded fasteners and replace any bolts or clips that are severely corroded.
- Ensure the cable is wound neatly on the drum and not twisted; misrouting may cause premature wear.
- Inspect the mounting bracket and surrounding bodywork for rust; treat or repair corrosion to prevent repeat failures.
- After installation, operate the mechanism several times and check for free movement and secure fixing points.
Most Common Failure Reasons
Corrosion of the steel cable and drum is the primary cause of failure, especially in regions with road salt or high humidity. Other frequent issues include cable fraying or snapping, seized drum bearings, damaged mounting brackets from road impacts, and seized release mechanisms due to dirt and rust. Regular inspection and prompt replacement of worn components prevent the spare wheel from becoming inoperable when needed.
This spare wheel winch is an essential maintenance item for keeping the underbody spare usable. Supplied with OE references for easy identification: 9659556977 / 673504. Ideal for professional workshops and experienced DIYers undertaking body and undercarriage repairs on Peugeot 307 and 308 vehicles.
