Description
CITROEN C5 I and II Kombi rear lower light socket set
Functionality of bulbs not guaranteed
Light harness Citroën C5 I and II Kombi 6534JZ is an original part intended for the rear lower light of Citroën C5 cars of the first and second generation in the Kombi body version. It is a bundle with bulb sockets that ensures the supply of electric current to individual light functions (e.g. tail light, brake light, or fog or reversing light depending on the car’s equipment).
This part is suitable for auto mechanics and home repairers who solve problems with a non-functioning rear light, broken lines in the wiring or damaged bulb sockets. Replacing a harness is often faster and more reliable than repairing individual wires or contacts.
Technical information:
Manufacturer: PSA – Citroën / Peugeot
Model: Citroën C5 I Kombi, Citroën C5 II Kombi
Location: rear lower light – station wagon (probably side-specific depending on design)
Part Type: Tail Light Bulb Socket Wiring Harness
Product codes:
6534JZ
Other numbers:
NFP (manufacturer’s designation – No Further Production, no longer produced as a new original part)
Warning: The functionality of the bulbs is not guaranteed – it is necessary to consider replacing the bulbs with new ones according to the prescribed parameters (correct type, socket and power).
Installation recommendations:
– Before assembly, disconnect the battery to avoid short circuits and damage to the electrical system.
– Disassemble the rear lower light according to the service procedure (removing plastic covers, loosening screws, disconnecting the original harness).
– Check the condition of the connectors in the bodywork – clean the contacts and, if necessary, treat them with a suitable contact spray.
– When assembling the bundle, make sure that the sockets are correctly seated in the light body and tightly tightened to prevent loosening and flickering of the lights.
– Run the cabling in the original grooves and holders to avoid rubbing the insulation against the edges of sheet metal or plastics.
– After assembly, check the function of all light circuits (position, brake, fog light, reverse, direction indicators depending on the equipment) before closing the trunk panel definitively.
– Use only bulbs that meet the vehicle manufacturer’s specifications to avoid overloading the circuit or causing error messages from the bulb control system.
