Description
Socket with bulbs and a length of wiring for the left rear lamp of Peugeot 206 Combi. The connector and socket are not heated; they are fully functional.
Product Description
This replacement lamp socket with mounted bulbs and a piece of wiring is designed for the Left Rear Lamp of the Peugeot 206 Combi. It restores electrical contact and mechanical retention of the lamps, making it a quick repair for tail light, brake light and indicator failures caused by damaged sockets or wiring. Supplied as a ready-to-fit assembly, it reduces troubleshooting time and is suitable for professional workshops and DIY mechanics familiar with rear light repairs.
Technical Information
- Manufacturer: Stellantis / Peugeot
- Model: Peugeot 206 Combi
- Product Codes: 6350R4
- Other Numbers: None Provided
Function and Application
The socket holds the rear lamp bulbs and provides the electrical connection between the vehicle wiring harness and the lamp assembly. It supports the following functions depending on the lamp cluster design: tail light, stop light (brake), and turn signal. This assembly is intended for the left-side rear lamp of Peugeot 206 Combi body style.
Common Failure Modes
Lamp sockets and short wiring sections most often fail due to corrosion from moisture ingress, heat-induced plastic deformation or cracking from repeated bulb changes and vibration, and poor contact from oxidised terminals. Water entry through seals or damaged grommets accelerates corrosion and can short circuits or cause intermittent lighting faults.
Replacement Guidance
General replacement steps for the Left Rear Lamp Socket (typical procedure):
- Disconnect the Battery Before Work To Avoid Short Circuits And Risk To Vehicle Electronics.
- Access The Rear Lamp: Open The Tailgate/Boot And Remove The Interior Trim Or Carpet Panel To Reach The Lamp Holder.
- Remove The Lamp Assembly Or Reach Into The Back Of The Lamp Cluster To Release Retaining Clips/Screws.
- Unplug The Existing Socket From The Vehicle Harness And Remove The Old Socket From The Lamp Housing.
- Fit The New Socket With Wiring, Ensuring Correct Orientation And Secure Retention Of Bulbs And Clips.
- Reconnect The Connector To The Vehicle Wiring, Reinstall The Lamp Assembly And Interior Trim.
- Reconnect The Battery And Test All Light Functions (Tail, Brake, Indicator) Before Final Reassembly.
Installation Recommendations
- Always Disconnect The Battery Before Starting Work To Protect Vehicle Electronics.
- Inspect The Lamp Housing Seals And Grommets; Replace Or Reseal If Signs Of Water Ingress Are Present.
- Check Bulb Types And Ratings When Fitting—Use Correct Wattage Bulbs To Avoid Overheating The Socket.
- Ensure Connectors And Terminals Are Clean; Apply Dielectric Grease To Contacts To Reduce Future Corrosion.
- Secure Wiring Away From Sharp Edges And Moving Parts To Prevent Chafing And Breakage.
Why Replace This Part
Replacing the socket and short wiring section is a cost-effective repair when lights are intermittent, do not illuminate, or when connectors are visibly corroded or melted. Renewing the socket restores reliable contact and prevents electrical faults that can lead to lamp failure or blown fuses.
