Description
Socket for the left rear outer lamp in the wing for Peugeot 406 Combi. Supplied with a short length of wiring; we recommend replacing the bulbs.
This replacement bulb holder is designed for the left rear outer lamp mounted in the wing of the Peugeot 406 Combi. It provides a direct, serviceable solution for damaged or corroded rear lamp connections and is ideal for professional workshops and competent DIY mechanics. The part improves electrical contact and secures the bulb in the lamp housing, restoring reliable tail, brake and indicator lamp function. Often searched under part number 6350H5, this socket comes with a short pigtail of wiring to simplify fitting.
Practical Advantages
- Restores secure electrical contact and correct bulb positioning.
- Includes a short length of wiring for quicker replacement and better mechanical strain relief.
- Straightforward fitment suitable for garage repairs and DIY maintenance.
- Recommended to replace bulbs at the same time to avoid future failures.
Fitment And Function
Fits: Peugeot 406 Combi (Estate) – left rear outer lamp in the wing. The socket secures and supplies the tail, stop and indicator bulbs depending on lamp configuration. It is a passive electrical connector that transfers current from the vehicle wiring to the bulbs and holds the bulbs mechanically in the lamp assembly.
Installation Recommendations
- Work Performed By: Suitable for experienced DIYers and professional mechanics. If uncertain about access steps, follow vehicle repair manual procedures.
- Basic Steps: Remove rear lamp assembly or access through inner wheel arch/boot service panel, unplug the damaged socket, cut back or remove old wiring as needed, fit the new socket and connect the pigtail (observe correct polarity), reseat bulbs and lamp housing, check lamp operation.
- Safety: Disconnect the battery or isolate the circuit before doing any electrical work to prevent short circuits and avoid accidental bulb activation.
- Best Practice: Replace bulbs when fitting a new socket, clean mating surfaces, and use dielectric grease on contacts to reduce future corrosion. Secure wiring away from sharp edges and heat sources.
Most Common Failure Causes
- Corrosion of contacts due to moisture ingress, leading to poor contact or intermittent operation.
- Heat damage or melting from overheated bulbs (incorrect bulb type or excessive wattage).
- Mechanical wear or broken terminals from vibration and repeated bulb changes.
- Abrasion or damage to wiring insulation causing short circuits or open circuits.
Technical Information
- Manufacturer: Stellantis (Citroën / Peugeot)
- Model: Peugeot 406 Combi
- Product Codes: 6350H5
- Additional Numbers: NFP
Tip: When replacing the socket, verify the correct bulb type and wattage for your specific lamp unit, and check the lamp sealing to prevent future moisture entry. A careful installation will extend service life and reduce repeat visits.
