Description
Rear right taillight lamp for Citroën Xsara Picasso up to 2004
Passenger Side
Original Citroën
Product Overview
Genuine rear right taillight assembly designed for Citroën Xsara Picasso models produced up to 2004. This passenger-side rear lamp is an OEM Citroën unit (original equipment), offering direct fit and finish for fast replacement after impact damage or wear. Ideal for professional workshops and DIY mechanics searching by part number 9631563980 or 6351N0.
Key Benefits
- Direct OEM fit for reliable alignment and secure mounting.
- Restores original lighting performance and appearance.
- Simplifies replacement—fits the original mounting points and connector.
- Common search terms supported: rear right taillight Citroën Xsara Picasso, 9631563980, 6351N0, passenger side rear lamp.
Technical Information
- Manufacturer: Citroën
- Model: Xsara Picasso
- Product Codes: 9631563980, 6351N0
- Other Numbers: Original Citroën Part
Fitment And Compatibility
Fits Citroën Xsara Picasso passenger-side rear for vehicles manufactured up to 2004 (pre-facelift models where this OEM code applies). Verify model year and side before installation. Part commonly sought by its OEM numbers (9631563980, 6351N0) for accurate replacement.
Installation Recommendations
- Recommended Tools: Trim removal tools, socket set, screwdriver and a torque wrench for final fasteners.
- Basic Steps: Remove interior tailgate/trunk trim to access mounting bolts, unscrew fasteners, disconnect the wiring connector, remove the damaged lamp and install the new unit in reverse order. Ensure the connector locks fully and that the seal sits correctly against the body.
- Electrical Check: Test stop, tail, and indicator functions after installation. If bulbs are replaceable separately, check base contacts and consider fitting fresh bulbs to ensure full performance.
- Safety Tip: Work on a cool vehicle and protect painted surfaces with cloths. When handling electrical connectors, avoid pulling on wires—release the locking tab first.
Why The Part Commonly Fails
- Impact Damage: Rear collisions or minor parking impacts are the most frequent causes of lens cracks or broken mounting points.
- Water Ingress: Damaged seals or degraded gaskets allow moisture to enter, causing condensation, corrosion of contacts and bulb holders, and premature failure.
- Electrical Wear: Corroded connectors or poor earthing can lead to intermittent lighting or complete outage.
- UV And Ageing: Prolonged sun exposure can dull the lens and weaken plastic mounting tabs over many years.
Maintenance Tips
- Inspect seals and gaskets when replacing the lamp; replace degraded seals to prevent moisture ingress.
- Clean and apply dielectric grease to electrical contacts to reduce corrosion and improve connection longevity.
- Replace cracked lenses promptly to maintain lighting performance and vehicle safety compliance.
- After installation, ensure all lamp functions operate correctly during a short road test or with the vehicle lights activated.
