ABS ESP Control Module Bosch Citroën C4 9649462080 0265950370 4541E4

€61.00

Stellantis citroën peugeot
9649462080 0265950370 4541E4 NFP

1 in stock

Description

Control module, ABS pump, ESP unit, ABS Bosch block for Citroën C4. Hydraulic brake control block. Supplied with a piece of wiring.

Product Overview

Bosch ABS/ESP control module and hydraulic unit designed for Citroën C4. The unit integrates the electric pump, valves and electronic control to manage anti-lock braking (ABS) and electronic stability program (ESP) functions. Supplied with a length of wiring harness for easier connection, this module is suitable for professional garages and experienced DIY mechanics who replace ABS/ESP assemblies by part number. The item is commonly searched and identified by OEM codes listed below.

Technical Information

  • Manufacturer: Bosch
  • Model: Citroën C4
  • Product Codes: 9649462080, 0265950370, 4541E4
  • Additional Numbers: NFP

Compatibility

Fits Citroën C4 vehicles that use the listed product codes. When searching for a replacement, buyers frequently use the OEM numbers (9649462080 / 0265950370 / 4541E4) to ensure correct fitment. The unit is intended for C4 models equipped with Bosch ABS/ESP systems.

Replacement Procedure

Basic replacement steps for a competent technician or experienced DIYer:

  • Park the vehicle on a level surface and secure it. Engage the parking brake.
  • Disconnect the negative battery terminal before starting to avoid electrical damage.
  • Locate the ABS/ESP hydraulic unit in the engine bay (typically near the brake master cylinder) and remove any covers or components blocking access.
  • Carefully disconnect electrical connectors and cap brake lines to avoid fluid loss and contamination. Loosen and remove hydraulic lines from the unit.
  • Unbolt the module from its mount, remove the old unit and install the replacement. Tighten fasteners to manufacturer torque specifications.
  • Reconnect hydraulic lines and electrical connectors. Refill and bleed the brake system according to manufacturer procedure to remove air.
  • Clear fault codes and perform calibration/initialization of the ABS/ESP system with appropriate diagnostic equipment. Verify operation with a road test.

Installation Recommendations

  • Always disconnect the battery before removal or installation to protect the control electronics.
  • Use clean containers and fresh brake fluid when bleeding; contamination will damage valves and sensors.
  • After installation, perform a full brake bleed and use a diagnostic tool to reset and verify ABS/ESP faults. Some vehicles require initialization or adaptation procedures to restore normal function.
  • Observe correct torque values for hydraulic line fittings and mounting bolts to prevent leaks and mechanical stress.
  • If unsure about electrical coding or system initialization, have the final checks performed by a workshop with PSA diagnostic tools.

Why The Part Most Often Fails

  • Corrosion and moisture ingress in the hydraulic block or electrical connectors, especially on vehicles exposed to road salt or water.
  • Wear or failure of the electric pump motor or internal valves after high mileage.
  • Electrical faults caused by damaged wiring, poor grounding or connector corrosion leading to intermittent operation or complete failure.
  • Contamination of brake fluid (old or dirty fluid) that accelerates valve and piston wear inside the unit.

Notes

This is a Bosch ABS/ESP hydraulic control unit supplied with a piece of wiring harness. It is typically identified and purchased by its product codes. Proper installation, brake system bleeding and system initialization are essential for safe operation. Recommended for technicians and experienced DIYers familiar with high-pressure hydraulic systems and vehicle diagnostics.

Additional information

Weight 3 kg

Unless otherwise specified in the description, all photos are for illustrative purposes only.

We reserve the right to replace the ordered reference with the manufacturer's replacement reference.

The parts come from crashed vehicles, are carefully inspected, and we provide a 12-month warranty on functionality for them.