Description
Additional brake light for Peugeot 307 CC. Fully functional, tested.
This genuine-style third brake light (center high-mounted stop lamp) is designed for the Peugeot 307 CC and restores reliable rear signaling for safe driving. Ideal for professional workshops and DIY mechanics, the unit improves visibility to following traffic and meets original mount and connector specifications for easy replacement. Frequently searched by its product numbers, this brake light is a direct-fit option when replacing a damaged or non-functioning CHMSL on the 307 CC.
Technical Information
- Manufacturer: Peugeot (Stellantis)
- Model: Peugeot 307 CC
- Product Codes: 9641298880, 6350W5, 6351R8
- Additional Numbers: NFP
Compatibility
Designed primarily for Peugeot 307 CC (Coupe-Cabriolet), covering Phase I and Phase II model years commonly produced in the 2000s. Check the listed product codes against the part you are replacing to confirm fitment for your particular vehicle.
Installation Recommendations
- Required tools: trim removal tools, screwdriver set, small socket set, and a multimeter for quick electrical checks.
- Typical replacement steps: remove interior trunk/boot trim or convertible roof trim to access the lamp housing, disconnect the electrical connector, unfasten mounting screws, replace the unit and reassemble in reverse order.
- When fitting, ensure the sealing surface is clean and dry to prevent water ingress; apply a thin layer of dielectric grease to the connector pins if desired to protect against corrosion.
- After installation, verify proper function of the lamp by checking brake activation with someone observing the rear or using reflective surfaces; confirm secure mounting and wiring routing to avoid chafing.
Most Common Failure Causes
- Moisture Ingress: Damaged seals or cracked housing allow water to reach bulbs or LEDs and the connector, causing intermittent failure or corrosion.
- Connector Corrosion or Wiring Damage: Oxidation or frayed wires from vibration or previous repairs can interrupt the supply to the lamp.
- Impact or Body Damage: Rear-end collisions or lid/roof damage can break the lamp housing or mountings.
- Component Wear: Bulbs, LED modules, or internal circuit faults may fail over long service life—replacement is the standard remedy.
For workshops and home mechanics, replacing the third brake light is a straightforward repair that restores legal and safe brake signaling. Keep the mounting area clean and inspect seals and connector condition during installation to maximize service life.
