Description
VALEO Blower Motor N101812H for Citroën C1, Peugeot 107 and Toyota Aygo. For Vehicles With Air Conditioning.
Upgrade or replace the heating and air conditioning blower with the Valeo N101812H blower motor, designed for the shared Citroën C1 / Peugeot 107 / Toyota Aygo platform. This original-equipment style unit restores consistent airflow for cabin heating, ventilation and air conditioning systems, ensuring reliable comfort and rapid demisting. The motor is suitable for vehicles equipped with factory air conditioning and matches OE fitment and electrical connections for direct replacement.
Benefits
High-quality OE-compatible construction from Valeo provides dependable performance and long service life. Restoring proper blower operation improves HVAC efficiency, reduces cabin fogging times and eliminates noise and vibration caused by worn or imbalanced motors. Installation is straightforward for experienced technicians and competent DIYers familiar with interior trim removal.
Compatibility And Fitment
Designed For: Citroën C1, Peugeot 107, Toyota Aygo (shared platform models). Fitment Applies To Vehicles Equipped With Factory Air Conditioning. Always Confirm Part Numbers Against The Unit Being Replaced.
Technical Information
- Manufacturer: Valeo
- Model: Citroën C1 / Peugeot 107 / Toyota Aygo
- Product Codes: N101812H
- Additional Numbers: 6441V0, 6441V2
Installation Recommendations
For Safe And Reliable Replacement: Disconnect The Battery Before Starting Work To Prevent Short Circuits And Protect The Vehicle’s Electrical System. The Blower Motor Is Typically Located Under The Passenger-Side Dashboard (Behind Or Under The Glovebox) On These Models. Access Usually Requires Removal Of The Glovebox Or Lower Dash Trim To Reach The Fasteners And Electrical Connector.
Typical Replacement Steps:
- Disconnect The Battery.
- Remove The Glovebox Or Lower Dashboard Panels To Expose The Blower Housing.
- Unplug The Electrical Connector And Remove Mounting Screws Or Clips Holding The Blower Motor.
- Withdraw The Old Motor, Inspect The Housing For Debris, Clean The Fan Housing, Then Install The New Motor In Correct Orientation.
- Reconnect The Connector, Refit Panels And Reconnect The Battery. Verify All Fan Speeds And HVAC Functions.
If The Vehicle Exhibits No Fan Operation After Replacement, Check Related Fuses, The Blower Resistor/Control Module And Connector Integrity Before Replacing The Motor Again.
Why The Part Commonly Fails
Common Causes Of Blower Motor Failure Include Worn Brushes Or Commutator, Bearing Wear Leading To Excessive Noise Or Seizure, Debris Or Leaves Entering The Fan Housing And Physically Jamming The Impeller, And Corrosion Or Poor Electrical Connections Reducing Motor Performance. Water Ingress From Blocked Drainage Or Interior Moisture Can Also Shorten Motor Life.
Recommendations Before Installation
- Inspect And Replace The Cabin Filter If Necessary—A Clogged Filter Increases Motor Load.
- Clean The Blower Housing To Remove Debris That Can Damage The New Motor.
- Check Related Electrical Components Such As Fuses, Connectors And The Blower Resistor/Controller—Faults There Can Mimic Motor Failure.
- Use Proper Tools And Follow Manufacturer Trim-Removal Procedures To Avoid Breaking Clips Or Panels.
Notes For Mechanics And DIYers
This Valeo Unit Offers Direct-Fit Replacement For Mechanics Seeking A Reliable HVAC Blower Motor For The Citroën C1 / Peugeot 107 / Toyota Aygo Group. Perform A Quick Diagnostic (Fuse, Resistor, Voltage At Connector) Before Replacing The Motor To Avoid Unnecessary Parts Replacement. Proper Installation Restores Cabin Comfort And HVAC Performance.
